Inhaltsverzeichnis; Operation Condition - Carrier XCT7 Installations- Und Benutzerhandbuch

User Manual
CONTENTS
Safety ............................................................................1
Installation Instructions..................................................3
Installation Procedure..................................................13
Electric Wiring and Application....................................23
Failure Code...............................................................35
Trial Operation & Performance...................................40
Moving & Scrapping the Air Conditioner.....................41
Operating Range of Air Conditioner
indoor
cooling dry
outdoor
indoor
heating
outdoor

Operation condition:

To use the air conditioner efficiently, please ensure the
right conditions.
• The appliance must be fitted with means for disconnection from the supply mains having a contact separation
in all poles that provide full disconnection under overvoltage category Ill conditions. These means should be
incorporated in the fixed wiring in accordance with wiring rules.
• The appliance should be installed in accordance with national wiring regulations.
• Before connecting to the supply mains, the supply cord of the units should be connected to an all-pole full
disconnection circuit breaker that conforms to the requirements of IEC 60898. Please refer to 'Electric Wiring and
Application" on page 23 for details.
• To prevent electrocution, the installation of a residual current device (RCD), with a rated residual operating current
not exceeding 30 mA, is recommended.
• The maximum working pressure is 4.15MPa. This maximum working pressure should be considered when
connecting the outdoor unit to indoor units.
• The refrigerant used in the outdoor unit is R410A. Please refer to "Installation Procedure" on pages 20-21 of this
manual for information on refrigerant charging.
• The outdoor unit should only be connected to indoor units suitable for the same refrigerant.
• The unit is a partial unit air conditioner, complying with partial unit requirements of the International Standard and
must only be connected to other units that have been confirmed as complying with corresponding partial unit
requirements of the International Standard.
max. DB: 32 C WB: 23
o
min. DB: 18 C WB: 14
o
max. DB: 50 C WB: 26
o
min. DB: 5 C
o
max. DB: 21
min. DB: 15 C
o
max. DB: 27 C WB: 15
o
min. DB: 23 C
o
C
o
C
o
C
o
C
o