Maintenance; Troubleshooting - Inoksan inosmart INO-FBG010 Gebrauchsanweisung

Please press the wash button
to start washing.
Turn the rotary switch to select a
proper washing program depending on actual
contamination of the oven cabin. Press the button
to start washing.
Once washing is started, the oven performs a
preliminary set-up to meet washing conditions.
Discharge valve is closed, and cabin and
washwater temperature is brought to ideal
conditions.
Once the indication "OPEN DOOR" is
shown on the display, open the oven
door and load detergent.
Once the indication "PUT DTRG" is
shown on the display,
FBG 040 for 2 cover,
FBG 020 for 1 cover,
FBG 010 for 1 cover load detergent.
As long as the oven door is open, the
indication "CLOS DOOR" remains in
the display.
Close the oven door after detergent is
loaded.
The washing program selected will
automatically
shows the letters representing the
selected washing program, as well as the washing
time.
WARNING: Regardless of the washing program
selected, the oven
background work to
conditions before washing is started. Meanwhile,
letters representing the selected washing program
and washing time in hour and minute are
displayed.
Ideal washing conditions are set up as follows:

First the discharge valve is closed. This
procedure takes around 1 minute.

Cabin temperature of the oven should be
60°C. If actual cabin temperature is above
start. The display
automatically starts
meet ideal washing
60°C, cabin fans start during which the
indication "KAPI AC" appears on the
display. Meanwhile, the cooling LED
lights, indicating that cooling process is
in progress. If cabin temperature is below
60°C, burners start to bring cabin
temperature to 60°C.

Water temperature in steam generator
should be around 50-55°C. If water
temperature is above 55°C, cold water is
fed to the steam generator to cool down.
Otherwise, the steam generator burner
starts to increase water temperature above
55°C.
Cancelling the Washing Process
Press the on/off button to cancel
washing and switch off the oven.
Press the same button to open the
control panel. The display shows the message
"WASH END".
Meanwhile, press the rotary switch to
cancel washing. To prevent any detergent residue,
the oven starts flushing for 30 minutes and then
gets ready for cooking.
If you do not press the rotary switch within 10
seconds following the indication of the message
"YKMA IPTL", washing procedure is resumed.
WARNING: To prevent damage to the electrical
installation, do not use direct or highly
pressurized water for cleaning.
a

13. MAINTENANCE

 The user should not attempt to repair or replace
any device part or component.
 In case a dangerous situation is observed in the
device, first cut the gas and power connections,
and then call the authorized service. Intervention
in the device by unauthorized persons should be
avoided.

14. TROUBLESHOOTING

23