Parkside PPS 40 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 44

Troubleshooting
Warning lamp
switches on?
No output
current?
Output current
does not
decrease?
Air current cannot
be regulated?
HF-arc is not
created?
Bad ignition?
Plasma burner 8
is not ready for
operation?
Sparks fly
upwards, instead
of down through
the material?
Initial cut but not
completely drilled
through?
Slag formation on
interfaces?
44 GB/IE
Overheating protection
„
switched on.
Input voltage too high.
„
Machine faulty.
„
Overvoltage protection
„
activated.
Input voltage too low.
„
Connection cable cross-section
„
too low.
Compressed air hose
„
damaged or faulty.
Valve/manometer fails.
„
The burner switch is faulty.
„
Soldering point on the burner
„
switch or plug loosened.
Valve/manometer fails.
„
Burner wear parts damaged
„
or worn.
Current switch is switched off.
„
Air transmission is restricted.
„
Workpiece is not connected to
„
the ground terminal.
Burner sleeve 8c
„
penetrate the material.
Burner sleeve 8c
„
away from the material.
Apparently material was not
„
grounded properly.
Lifting speed is too quick.
„
Potential connection problem.
„
Tool/material creates heat.
„
Cutting speed too low or
„
current too high.
Plasma burner component
„
parts are worn 8b
Allow device to cool down.
„
Input voltage according to
„
type plate.
Machine must be repaired.
„
Allow device to cool down.
„
Observe input voltage
„
according to type plate.
New connection of the hose.
„
Renew electrode.
„
Change wear parts.
„
Switch the current switch
„
to "on".
Another indication of this is
„
a green flame. Check the air
supply.
Check the connections.
„
Increase the current.
„
does not
Reduce the distance between
„
the burner sleeve
is too far
material.
Check the connection for
„
correct grounding.
Reduce the speed.
„
Check all connections.
„
Allow the material to cool
„
down and then continue
cutting.
Increase the speed and/or
„
reduce the current until the
8c 8d 8e
, , , .
slag has been reduced to a
minimum.
Check and replace worn
„
parts.
8c and