Disk Or Ploughshare Adjustment; Working Speed - Checchi & Magli VR76 Bedienungsanleitung

15.0 - DISK OR PLOUGHSHARE ADJUSTMENT

15.1 Version with disks (export)
To regulate disk tilt, loosen screws (Fig. 9.E) and rotate the lever (Fig. 9.F).
- to increase degree of tilting, rotate downward
- to decrease degree of tilting, rotate upwards
Tighten screws after making the adjustment.
Regulation of the scraper (Fig. 9.G) adjusts movement of the dirt close to the row :
- for increased filling, rotate towards B (Fig. 9)
- for decreased filling, rotate towards A (fig. 9)
15.2 Version with ploughshares (standard)
To regulate mouldboard tilt (Fig. 9.H), position the plate (Fig. 9.L) at the desired
distance.

16.0 WORKING SPEED

The best working results are had with a forward speed of approximately 5-10 km/h,
depending on the type and the conditions of the soil.
D
C
G
L
30
F
E
H
VR76
N
M
FIG. 9