Functions Of The Tractor Driver; Distance Between Rows; Working Depth - Checchi & Magli VR76 Bedienungsanleitung

12.0 - FUNCTIONS OF THE TRACTOR DRIVER

Pay particular attention to the safety regulations in point 8.
Be especially careful when turning and reversing, because in view of its size, the
machine could cause damage to property or injury to persons in its operating range.
Do not operate in reverse with the vibroridger positioned on the ground.

13.0 DISTANCE BETWEEN ROWS

The space between rows can be adjusted by moving the parallelogram unit (fig. 8.C)
with respect to the frame (Fig. 8.D).
Minimum 60 cm.
Maximum 90 cm. (wider on request)

14.0 WORKING DEPTH

Each parallelogram unit is equipped with a support wheel that allows variation of
working depth using the regulator (Fig. 8.E).
14.1 Disk (or ploughshare) working depth
It is a general rule that the working depths of the ridgers indicated above should be
less than that of the flexible springs. Use regulators to adjust to this condition (fig.
8.F).
C
F
E
VR76
D
FIG. 8
29