Preparation Of The Machine (If Applicable) - Checchi & Magli VR76 Bedienungsanleitung

VR76
8.4 - Couple the machine only to a tractor of adequate power (see technical bulletin
referring to the model in use), and with a lift unit which complies with standards
specifically for tractors.
Adhere to the maximum stipulated weight on the axle, and the total mobile weight.
8.5 - When coupling and uncoupling the machine, pay maximum attention so as to
avoid the risk of crushing.
8.6 - It is strictly forbidden for the tractor to be driven by inexpert personnel or personnel
not in possession of a driving licence or in poor health.
8.7 - Never leave the operator position when the tractor is running.
Before leaving the tractor, lower the lift unit, stop the engine, operate the parking
brake and remove the ignition key from the control panel.
8.8 - Remember that the road-holding, steering and braking are affected by the
presence of a carried or towed machine.
8.9 - When driving on the road it is necessary to abide by the highway code of the
country in question.
8.10 - When transporting by road, with the machine lifted, put the hydraulic lift unit
control lever in the locked position.
8.11 - This machine works without operators on board; it is therefore strictly forbidden
to board the machine or go near its range of action.
8.12 - Do not lend the machine to inexpert persons: in the event of an accident,
you may be accountable.

9.0 - PREPARATION OF THE MACHINE (IF APPLICABLE)

The machine may be shipped partially disassembled in order to save space. If this is
the case, reassemble by referring to the figure on page 2 and the figures in the spare
parts catalogue on pages 53 to 55.
27