21.0- PARALLELOGRAM
It consists of:
- DOBLE ARTICULATED JOINT;
makes the adaptation to the ground
easier.
- FLEX WHEEL; adjustable in height
through handwheel(fig. 14.H).
It is possible to change the weight
on the press wheels by adjusting
both the reversible spring (fig. 14.F)
using the hanswheel (fig. 14.G) and
the spring (fig. 14.E).
22.0- PLANT CONTROL
It is possible to adjust the mobile
guard height (fig. 15):
- unscrew the nut(fig. 15.A) and
move the guard (fig. 15.E).
The phase can be changed with
respect to the ejector:
- unscrew B and C, turn the lever D
as shown in fig. 15.
23.0- DISTRIBUTOR DISK
The plant carrier bowls slide on a
self-adjusting disk. Therefore, it is
possible to adjust the position
through nuts(fig. 16.A).
If you tighten the nuts, the clearance
between disk and bowls increases.
If you unloose the nuts, the
clearance between disk and glasses
decreases until a particular pressure
level is attained.
24.0- PLOUGHSHARE
FORROW OPENER
It can be easily opened to be
cleaned. Unloosen the wing nut (fig.
17.A) and push the ploughshare
forward (fig. 17.B) by pressing the
safety lever (fig. 17.C), lower the
ploughshare. To close it: bring the
ploughshare back on a horizontal
position, push then backward and
lock the wing nut A.
48
H
D
E
E
D
A
A
B
TRIUM
G
F
FIG. 14
B
C
FIG. 15
FIG. 16
A
C
FIG. 17