Device; Automatic Connection When Switching On; Tws Mode; Activate Tws Mode - Silvercrest SLXL 20 B1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SLXL 20 B1
•
Now, start playback on your Bluetooth
•
Hold down the
beep will sound and the power/charge LED (8) will flash twice and then switch off.
9.2.1 Connect speaker to another Bluetooth
To connect the currently connected speaker to another Bluetooth
must first be disconnected by pressing the
feature on the currently connected Bluetooth
A beep will sound and the power/charge LED (8) will flash blue rapidly. Pairing mode is now active
and the speaker can be connected to another Bluetooth
The speaker will switch off automatically after 3 minutes if no connection is established.
The process must be restarted in this case.
The speaker will switch off automatically after 10 minutes if no signal is received in
®
Bluetooth

9.2.2 Automatic connection when switching on

The speaker automatically connects to the last connected Bluetooth
If this is not the case, you will need to connect manually. Please consult the operating instructions of
®
your Bluetooth

device.

9.3 TWS mode

By purchasing a second speaker of the same type (SLXL 20 B1), it is possible to pair both speakers
and use them as a stereo speaker system. A second speaker can be purchased at
www.lidl.de/de/onlineshop [in German].
TWS: 'True Wireless Stereo'.
This function allows two speakers to be coupled.
The left speaker acts as the main speaker, which is connected to a Bluetooth
transmits the audio signals it receives to the second (right) speaker.

9.3.1 Activate TWS mode

A speaker must not be connected to a Bluetooth
necessary, disconnect any existing connection.
•
Switch on both speakers and select which speaker should act as the left speaker (main speaker).
•
Press the (2) button on the left speaker. A beep will sound and the TWS LED (9) will flash
green rapidly during pairing.
•
Now, briefly press the (3) button on the other (right) speaker.
•
A beep indicates the coupling was successful. TWS mode is now active.
•
The TWS LED (9) will light up green on both speakers.
The two speakers will switch off automatically after about 6 minutes if no connection is
made within that time. The coupling process must be restarted after switching the speakers
28 - English
button (7) for approximately 3 seconds to end the Bluetooth
mode for 10 minutes.
®
device. Playback occurs via the connected speaker.
®
device
(3) button. Alternatively, you can disable the Bluetooth
®
device.
®
device.
®
device when TWS mode is activated. If
®
®
device, the existing connection
®
device when switched on.
®
connection. A
®
device . It