Connecting The Supply Voltage Or Signal Cable; Service Connector; Technical Data - Endress+Hauser Proline Prosonic Flow 92F Sicherheitshinweise

Proline Prosonic Flow 92F
Connecting the supply
voltage or signal cable

Service connector

Technical data

Endress+Hauser
The terminal assignment and the connection data for the supply voltage are identical for all devices, regardless
of the device version (type code).
!
Note!
A graphic illustration of the electrical connections is provided on Page 22.
Terminal assignment /connection data
Prosonic 92F**-***********A
Prosonic 92F**-***********W
Prosonic 92F**-***********H
Prosonic 92F**-***********K
The service connector (for connection, see Fig. 3 to Fig. 7, e) is only used to connect service interfaces
approved by Endress+Hauser.
#
Warning!
The service connector may not be connected in a potentially explosive atmosphere.
Dimensions
The dimensions of the Ex transmitter housing and the sensor correspond to the standard versions.
Please refer to the Technical Information for these dimensions.
!
Note!
Associated "Technical Information":
Proline Prosonic Flow 92F TI073D/06/...
ATEX II2G & II1/2G; IECEx Zone 1 & Zone 0/1
Terminals 1 (+)
Terminal Transmitter power supply /
designation 4 to 20 mA HART
Safety related
 35 V (U
max
values
Terminals 1 (+)
Terminal
designation
Safety related
values
Terminals 1 (+)
Terminal
designation
Safety related
values
2 (–) 3 (+)
Optional
pulse/status output
 35 V (U
= 253 V) = 253 V)
max
2 (–)
PROFIBUS PA
U = 35 V
(U = 253 V)
max
2 (–)
FOUNDATION Fieldbus
U = 35 V
(U = 253 V)
max
0
4 (–)
23