Connecting Lead Wire; Preparing For Session - TensCare perfect PFE Bedienungsanleitung

Do NOT put,
leave near sources of heat, in direct
strong sunlight, in a high temperature
location, in a pressurized container or in
a microwave oven.
Do NOT immerse in water or sea water,
or get wet.
Do NOT short-circuit.
Do NOT connect the device unless the
battery cover is in place.
If battery leakage occurs and comes in
contact with the skin or eyes, wash
thoroughly with lots of water and
immediately seek medical attention.
Warning: Keep batteries out of the
reach of children to prevent them from
swallowing them
swallowed by child, contact doctor
immediately.
Caution NEVER attempt to
recharge an alkaline battery –
There is a risk of explosion.
Caution Do not mix old, new or
different types of batteries as
this may lead to battery leakage or low
battery indication.
Disposal: Always dispose of batteries
responsibly according
government guidelines. Do not throw
batteries onto a fire. Risk of explosion.
store or
by mistake. If
to local
23
13.2. CONNECTING
WIRE
Insert the lead wire plug into the base of
the unit.
Connect the lead from the base of
the unit to the lead in the probe.
Push the pin ends firmly into the pigtail
ends of the probe lead.
The lead wires may be damaged by
rough handling, and should be treated
with care.
Lead wire colour coding.
The ends of the lead wire are coloured
black or red. This coding is provided for
some professional uses. For most
purposes, the orientation makes no
difference, and you can ignore this
colour coding.
13.3. PREPARING
SESSION
1) Before using perfect PFE you will
need to visit the toilet.
2) Lubricate the
surfaces and probe tip with a water-
based lubricant, such as TensCare
Go Gel or water.
Caution: Do not use a silicone
based lubricant
stimulation contacts as it may
LEAD
FOR
metal electrode
on the