Operating Instructions - TensCare perfect PFE Bedienungsanleitung

12.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit on, press the
ON
ON button and hold for 3 to 5
seconds until the display
shows.
OFF
To turn the unit off, press ▼
button to remove keypad lock and press
the OFF button and hold for 3 to 5
seconds until the display stops.
At first use, or after changing batteries,
the display shows that the unit is
automatically set in programme STRES
at zero strength.
When switched on
automatically start in the programme
which was being used when it was last
switched off.
The unit will turn off automatically:
• When the Timer reaches zero,
• If it is left at zero strength for more
than 5 minutes.
Note: Always check unit is
OFF before
removing probe or pads.
The backlight will turn off 10 seconds
after the last button press.
STRENGTH CONTROLS
▲
The buttons marked ▲ and ▼
are the strength controls.
To increase strength, press
▼
and hold down the button ▲
until required
achieved.
the unit will
applying or
strength is
20
To decrease the strength, press and
release the button ▼.
To increase strength in steps of 1 mA,
press and release the button ▲.
The unit will remain in the WORK part
of the cycle for 5 seconds while
intensity is being adjusted.
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you (probe inserted
correctly). Perfect PFE detects a
disconnection and
returns the strength to zero.
The unit has 99 levels of strength. If you
hold down the button ▲ for 3 to 5
seconds, the strength will start scrolling.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
The yellow LED on the output socket
indicates that there is an active output.
The display will remain on for 5 seconds
after the plug is removed.
Caution: should be observed
when using the Perfect PFE at
high strength settings. Perfect
PFE has a Yellow LED light on output
socket which means the output will
exceed 10 mA (R.M.S) or 10 V (R.M.S)
averaged over any period of 1 sec.
Prolonged use at high settings may
cause muscle injury
inflammation.
automatically
or tissue