Connecting Lead Wire; Preparing For Session - TensCare itouch sure Bedienungsanleitung

Caution NEVER attempt to
recharge an alkaline battery.
Risk of explosion.
Caution Do not mix old, new or
different types of batteries as
this may lead
leakage or low battery indication.
Disposal: Always dispose of batteries
and device responsibly according to
local government guidelines. Do not
throw batteries onto a fire. Risk of
explosion.
12.2. CONNECTING
WIRE
Insert the lead wire plug into the base of
the unit.
Connect the lead from the base of
the unit to the lead in the probe.
Push the pin ends firmly into the pigtail
ends of the probe lead.
The lead wires may be damaged by
rough handling, and should be treated
with care.
12.3. PREPARING
SESSION
1) Before using itouch sure you will
need to visit the toilet.
2) Lubricate
surfaces and probe tip with a water-
based lubricant, such as TensCare
Go Gel or water (see K-GO).
to battery
decrease the effectiveness of the
itouch sure's muscle stimulation.
3) Choose a comfortable position, such
as lying down on your bed on your
side with your knees raised.
LEAD
4) After the wire is securely connected,
insert the probe into your vagina, in
the same way as you would a
tampon, until only the plastic rim at
the base of the probe is visible.
5) The
electrical pulse and should be in
contact with the main part of the
muscle at all times. The tissues close
to the entrance are more sensitive,
so you should avoid stimulating
FOR
them.
Ensure that the probe is aligned so
that the contact plates are to the
sides and the longer sides of the
positioning end rim are vertical.
20
the metal
Caution: Do not use a silicone-
based lubricant
stimulation contacts as it may
Warning: Ensure
itouch sure is switched OFF
before inserting the probe.
metal parts conduct
electrode
on the
that the
the