Connecting Lead Wires; Preparing For Session - TensCare perfect mama+ Bedienungsanleitung

Battery Warnings
Do NOT pierce, open, disassemble, or
use in a humid and/or corrosive
environment.
Do NOT expose to temperatures over
60°C(140F).
Do NOT put,
leave near sources of heat, in direct
strong sunlight, in a high temperature
location, in a pressurized container or in
a microwave oven.
Do NOT immerse in water or sea water,
or get wet.
Do NOT short-circuit.
Do NOT connect the device unless the
battery cover is in place.
If battery leakage occurs and comes in
contact with the skin or eyes, wash
thoroughly with lots of water and
immediately seek medical attention.
Warning: Keep batteries out of the
reach of children to prevent them from
swallowing them
swallowed by child, contact doctor
immediately
.
Caution NEVER attempt to
recharge an alkaline battery.
Risk of explosion.
Caution Do not mix old, new or
different types of batteries as
this may lead
leakage or low battery indication.
Disposal: Always dispose of batteries
and device responsibly according to
local government guidelines. Do not
store or
by mistake. If
to battery
19
throw batteries onto a fire. Risk of
explosion.
11.2. CONNECTING LEAD
WIRES
Connect the lead wires to each channel
as shown on the image.
CH1
Channel 1
Insert the lead wire for the pads to be
used under the bra line into Channel 1
at the base of the machine.
The lead wire for the pads which will be
used on your lower back should then be
inserted into Channel 2.
The lead wires may be damaged by
rough handling, and should be treated
with care.
11.3. PREPARING FOR
SESSION
1) After the lead wires are securely
connected you will need to ask your
birthing partner
electrode pads into the correct
position on your back. To ensure
good adhesion of pads, the area of
skin they are going to be applied to
needs to be clean, dry, and free from
grease or powder.
2) For contraction, episiotomy pain or
perineal tear, place the top pair of
pads (connected to CH1) either side
of the spinal column 2 inches (50
CH2
Channel 2
to place the