Installing The Battery; Connecting Lead Wire; Preparing For Session - TensCare Elise Handbuch

Keep batteries out of the reach of small
children.
Disposal: Always dispose of batteries
responsibly
government guidelines. Do not throw
batteries onto a fire. Risk of explosion.
12.2. INSTALLING
1) Remove the battery cover by
pressing down the centre of the battery
cover and slide downwards.
2) Insert the battery into the unit. Line
up the 3 connectors on the battery with
the contact in the unit. Slide in and
press down.
3) Replace the battery cover.
12.3. CONNECTING
Insert the lead wire plug into the base of
the unit.
Connect the lead from the base of
the unit to the lead in the probe.
Push the pin ends firmly into the pigtail
ends of the probe lead.
The lead wires may be damaged by
rough handling, and should be treated
with care.
Downloaded from www.Manualslib.com
according to
BATTERY
WIRE
manuals search engine
12.4. PREPARING
SESSION
1) Before using Elise, you will need to
local
visit the toilet.
2) Lubricate
surfaces and probe tip with a water-
based lubricant, such as TensCare
THE
Go Gel or water.
Caution: Do not use a silicone
based
stimulation contacts as it may
decrease the effectiveness of the
Elise's muscle stimulation.
3) Choose a comfortable position, such
as lying down on your bed on your
side with your knees raised.
Warning: Ensure the Elise is
switched OFF before inserting
LEAD
the probe.
4) After wires are securely connected,
insert the probe into the vagina, in the
same way as a tampon, with the two
silver plates side to side: one plate on
left and the other on the right, until only
the flange at the end is visible. The
probe will naturally position itself with
the widest part of the flange vertically.
The metal parts conduct the electrical
pulse and should be in contact with the
main part of the muscle at all times. The
tissues close to the entrance are more
sensitive,
stimulating them.
19
FOR
the metal electrode
lubricant on
so you should avoid
the