Electrical Wiring; Dipswitch Setting - Carrier 40VK005S-7S-QEE Betriebs- Und Montageanleitung

Electrical Wiring

Dipswitch Setting

• The dipswitch is dialled to "On" position with the overline at the state of strapping if the code or overline status is
"1" The dipswitch is dialled to "Off" position with the overline at the state of disconnection if the code or overline
status is "0"
• In the table below, the choice in the box "
Indoor Units PCB
In the following table, 1 represents ON and 0 represents OFF. Definition principles of code switches:
SW01 is used to set the capabilities of the master and slave indoor units as well as the indoor unit; SW03 is
used to set the address of the indoor unit (combine original communication address and address of centralized
controller).
(A) Definition and description of SW01
[1]
Address
of wire
SW0 1_1 controlled
SW0 1_2 indoor
SW0 1_3 unit
SW0 1_4 (group
address)
[5]
SW0 1_5
SW0 1_6 Capability
SW0 1_7 of Indoor
SW0 1_8 Unit
Note : A wired controller can connect to at most sixteen indoor units.
" refers to the setting of the socket/overline before delivery.
[2] [3] [4]
0 0 0 0
0 0 0 1
0 0 1 1
0 0 1 1
... ... ... ...
1 1 1 1
[6] [7] [8]
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 0
0 1 0 1
0 1 1 0
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
1 0 1 1
1 1 0 0
1 1 0 1
1 1 1 0
1 1 1 1
Address of wire controlled indoor unit (group address)
0# wire controlled master unit (default)
1# (wire-controlled slave unit)
2# (wire-controlled slave unit)
3# (wire-controlled slave unit)
15# (wire-controlled slave unit)
Capability of indoor unit
0.6HP
0.8HP
1.0HP
1.2HP
1.5HP
1.7HP
2.0HP
2.5HP
3.0HP
3.2HP
4.0HP
5.0HP
6.0HP
8.0HP
10.0HP
15.0HP
18