Carrier 40VK005S-7S-QEE Betriebs- Und Montageanleitung Seite 16

Installation Procedures
air outlet joint
right coupling
(4) Lead the connection tubing (liquid pipe and gas pipe) through the hole into the wall, or connect piping and wiring of
the indoor unit, and then put the connection tubing and connecting line through from the inside wall
Fitting the Mounting Plate and Positioning the Wall Hole
When the mounting plate is first fixed
1. Based on the neighboring pillars or lintels, conduct an accurate leveling for the plate to be fixed against the wall,
then temporarily fasten the plate with a steel nail.
2. Recheck the proper accurate levelling of the plate, by hanging a thread with a weight from the central top of the
plate, then fasten the plate securely with the attachment steel nail.
3. Find the wall hole location A using a measuring tape.
40VK005S-40VK012S
Pay attention to the following points before installation of machine:
1. Take out cushion blocks on the left and right-angle beads as
shown in the following Figure.
drain pipe
A=95mm
heat insulating material
signal wire
drain pipe
left coupling
electric connection of
indoor & outdoor units
40VK016S-40VK024S
40VK028S-40VK030S
16 9
tube
tube plate
A=125mm
A=140mm