Damages Of Suction Plate; Maintenance And Care; Maintenance; Mechanics - probst VPH-150-GREENLINE Betriebsanleitung

Maintenance and care

6.8

Damages of suction plate

Avoidance of damages:
Otherwise the rubber seal on the suction plate could be damaged (danger of pressure loss).
Product could fall down. Danger of accidents!
To avoid damages of the rubber seal on the suction plate (chinks, abrasion) take notice, that:
•
during the operation (lifting, transporting and lowering) with the device, the suction plate does not
brush or pump against other products or materials.
7 Maintenance and care
7.1

Maintenance

To ensure the correct function, safety and service life of the device the following points must be executed in
the maintenance interval.
Used only original spare parts, otherwise the warranty expires.
All operations may only be made in unpressurised, electro less and closed state of the device!
7.1.1

Mechanics

MAINTENANCE PERIOD
Initial inspection after
25 operating hours
Every 50 operating hours
At least 1x per year
(shorten the inspection interval
in case of harsh operating
conditions)
52710008/52710009
Work to be carried out
•
Check or retighten all fixing screws
(may only be carried out by a qualified person).
•
Retighten all fixing screws (make sure that the screws are retightened according to
the valid tightening torques of the corresponding strength classes).
•
Check all existing safety elements (such as folding pins) for proper function and
replace defective safety elements. → 1)
•
Check all joints, guides, pins and sprockets, chains for proper function, readjust or
replace if necessary.
•
Check gripper jaws (if present) for wear and clean, replace if necessary.
•
All existing sliding guides, rack gears and joints of moving parts or machine
components must be greased / lubricated to reduce wear and for optimum
movement sequences (recommended grease: Mobilgrease HXP 462).
•
Lubricate all grease nipples (if present) with grease gun.
•
Inspection of all suspension parts, as well as bolts and brackets. Inspection for
cracks, wear, corrosion and functional safety by an expert.
1)
18 / 24
V7 GB