Function Control; General; Electric - probst VPH-150-GREENLINE Betriebsanleitung

Safety
•
While using the vacuum lifting device is the stay of persons in the working area forbidden. Except it is
indispensable. Caused of the way of using the vacuum lifting device , e.g. if the device must be leaded by
hand.
•
While using the vacuum lifting device be sure that there are no persons in the working area. Danger to
Life!!
•
The device must never be subjected to a force acting in a lateral direction due to diagonal pulling.
•
Do not lift any components off-centre, because that could fall down. Danger of tilting!
•
Release the load only when it is completely safely resting on the surface. Keep fingers away from the
load when you release it as they can be crushed!
•
The carrying capacity / working load limit (WLL) and the nominal width the vacuum lifting device must
not be exceeded.
•
Do not pull out stuck or tightened loads with the device.
The jerky raising or lowering of the device with or without load is prohibited!
Unnecessary vibrations must be avoided. Just like driving fast with the carrier/ hoist over uneven terrain!
Danger to life: Load could fall off or load handling equipment could be damaged!
In general, only drive at walking speed with the load lifted!
2.9

Function Control

2.9.1

General

•
Before every usage of the device check the functions and the working condition.
•
Maintenance and lubrication are only permitted when device is shut down!
•
Do not use the device, until all faults which can cause safety hazards are removed.
•
If there are any cracks, splits or damaged parts on any parts of the device, immediately stop using it.
•
The operating instructions must be available at the workplace every time.
•
Do not remove the type plate of the machine.
•
Unrecognisable information signs (such as regulatory or prohibition signs) must be replaced.
2.9.2

Electric

•
Check all electric cables for connection before each use.
•
Defective electrical parts may be exchanged only by qualified personnel in the dead condition.
•
The electric cables must be free of breaks and abrasion. Take care that there are no outstanding edges,
where the hoses could get stuck.
52710008/52710009
8 / 24
V7 GB