Operating The Quick Stick; Clearing A Clogged Discharge Chute; Operating Tips - Toro SnowMax 724 QXE Bedienungsanleitung

Operating the Quick Stick

Note:
The blue knob must be fully pressed to release
the latch and operate the Quick Stick
Figure 17
Clearing a Clogged
Discharge Chute
WARNING
If the auger/impeller is running but there is no
snow coming out of the discharge chute, the
discharge chute may be clogged.
Never use your hands to clear a clogged
discharge chute. This could result in personal
injury.
1. While remaining in the operating position,
release the self-propel handle.
2. Engage the auger.
3. Push down on the handle to raise the front of
the machine a few centimeters (inches) off the
pavement, then lift the handles quickly to bump
the front of the machine onto the pavement.
4. Disengage the auger.
5. Repeat steps 1 through 4, if necessary, until
a stream of snow comes out of the discharge
chute.
®
Important:
chute by bumping the front of the machine, shut
off the engine, wait for all moving parts to stop,
® . and use a snow-cleanout tool (not included).
Important:
by bumping the front of the machine on the
pavement may cause the skids to move. Adjust
the skids and tighten the skid bolts securely; refer
to

Operating Tips

The auger can throw stones, toys, and other
foreign objects and cause serious personal
injury to you or bystanders.
• Keep the area to be cleared free of all
• Keep all children and pets away from the
•
g030118
•
•
•
11
If you cannot unclog the discharge
Unclogging the discharge chute
Checking and Adjusting the Skids (page
WARNING
objects that the rotor blades could pick up
and throw.
area of operation.
Remove the snow as soon as possible after it falls.
Overlap each swath to ensure complete snow
removal.
Discharge the snow downwind whenever possible.
If the machine does not propel itself forward on
slippery surfaces or in heavy snow, push forward
on the handle, but allow the machine to work at
its own pace.
14).