Figure 1; Introduction - Toro SnowMax 724 QXE Bedienungsanleitung

Introduction

This machine is intended to be used by residential
homeowners. It is designed primarily for removing
snow from paved surfaces, such as driveways and
sidewalks, and other surfaces for traffic on residential
or commercial properties. It is not designed for
removing materials other than snow, nor is it designed
for clearing off gravel surfaces.
Read this information carefully to learn how to operate
and maintain your machine properly and to avoid
injury and machine damage. You are responsible for
operating the machine properly and safely.
You may contact Toro directly at www.Toro.com
for product safety and operation training materials,
accessory information, help finding a dealer, or to
register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the machine. Write the numbers in the space
provided.
Important:
With your smartphone or tablet, scan
the QR code on the serial number decal to access
warranty, parts, and other product information.
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
CV
SnowMax 724 QXE Snowthrower
Model No. 38721—Serial No. 400000000 and Up

Figure 1

Figure 1
Register at www.Toro.com.
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
This product complies with all relevant European
directives; for details, please see the separate product
specific Declaration of Conformity (DOC) sheet.
Important:
If you are using this machine above
1500 m (5,000 ft) for a continuous period, ensure
that the High Altitude Kit has been installed
so that the engine meets CARB/EPA emission
regulations. The High Altitude Kit increases
engine performance while preventing spark-plug
fouling, hard starting, and increased emissions.
Once you have installed the kit, attach the
high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service
Dealer to obtain the proper High Altitude Kit and
high-altitude label for your machine. To locate
a dealer convenient to you, access our website
at www.Toro.com or contact our Toro Customer
Care Department at the number(s) listed in your
Emission Control Warranty Statement. Remove
the kit from the engine and restore the engine to
its original factory configuration when running the
g215700
engine under 1500 m (5,000 ft). Do not operate an
engine that has been converted for high-altitude
use at lower altitudes; otherwise, you could
overheat and damage the engine.
If you are unsure whether or not your machine has
been converted for high-altitude use, look for the
following label
Original Instructions (EN)
Form No. 3415-784 Rev A
Operator's Manual
Figure 2
Safety-alert symbol
(Figure 3).
All Rights Reserved *3415-784* A
Printed in Mexico
g000502