Operating The Quick Stick - Toro Power Max Heavy Duty 1028 OHXE Bedienungsanleitung

WARNING
If the auger and impeller continue
to rotate when you release the
auger/impeller lever, you could seriously
injure yourself or others.
Do not operate the machine. Take it to an
Authorized Service Dealer for service.
Operating the Quick Stick®
Hold the blue trigger cap down to use the Quick Stick
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute
and chute deflector into position
Figure 28
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the
left; move the Quick Stick to the right to move the
discharge chute to the right
Figure 29
(Figure 28).
g001014
(Figure 29).
g018894
If the chute does not turn as far to the left as it does to
the right, ensure that the cable is routed to the inside
of the handles. Refer to
(page 5).
Moving the Chute Deflector
Hold the blue trigger cap down and move the Quick
Stick forward to lower the chute deflector; move it
rearward to raise the chute deflector
17
1 Installing the Upper Handle
(Figure 30).
Figure 30
g001016