Geberit ESG 3 Betriebsanleitung Seite 41

Fault
LED displays for
<General
malfunction>
and <Ready for
welding> light
up
LED displays for
<General
malfunction>
<Welding
procedure>
and <Ready for
welding> light
up
<Ready for
welding> LED
display flashes
and <General
malfunction> LED
display lights
up
<General
malfunction> LED
display flashes
B1157-002 © 01-2015
966.475.00.0 (01)
Cause
Operating at too
low an ambient
temperature
Fault current while
welding, e.g. as a
result of dampness
,
on electrical
connections
Too many serial
welding joints
Electrofusion
machine is
defective
Actions
Only operate the
electrofusion machine in
the permitted
temperature range (see
chapter <Technical data>)
Disconnect the mains
plug
Keep electrofusion
machine, all cables as well
as Geberit electrofusion
coupling or Geberit
electrofusion tape for
anchor point dry and
clean
Reduce number of
welding joints (refer to the
table on the back cover
page)
Send the electrofusion
machine to a qualified
service centre
EN
1)
41