Geberit ESG 3 Betriebsanleitung Seite 36

EN
Carrying out welding with the Geberit
electrofusion machine ESG 3
Prerequisite
• Pipes, fittings and welding joints are dry and free of dirt
• Pipes and fittings are prepared in accordance with the
installation manual for Geberit electrofusion couplings
• Pipe surfaces are prepared in accordance with the installation
manual for Geberit electrofusion tape for anchor point
DANGER
Danger of fatal electric shock
WARNING
Risk of injury from burns
CAUTION
Faulty welding
36
Do not weld wet or water-filled pipes
An isolation transformer must be included in the circuit
when carrying out electrofusion work in damp areas
Allow the Geberit electrofusion coupling or Geberit
electrofusion tape to cool down before conducting a
secondary welding procedure
Do not touch the pipe, electrofusion coupling, plug
contacts or electrofusion tape during the welding
procedure or during the cooling-down phase
The pipe to be welded must be kept in a tension-free
position during the welding procedure and the cooling-
down phase
Air draughts through the pipe interior must be avoided
B1157-002 © 01-2015
966.475.00.0 (01)