Troubleshooting - Concept VP4290 Bedienungsanleitung

EN
• The filter should be cleaned or replaced whenever visibly fouled, or when the suction power is low. The filter
should be checked after each use of the vacuum cleaner.
• To prevent the vacuum cleaner from getting damaged, never use it without the filter installed properly.
• A suitable filter type is available at your local retailer, or it can be ordered from the manufacturer.

TROUBLESHOOTING

Problem
Motor does not run.
Reduced suction power.
Operation time after full
recharging is less than 1
minute.
Vacuum cleaner heats up.
SUPPLEMENTAL ACCESSORIES
The following appliance accessories can be supplemented by purchase:
Filter Order Code 44291530
Accumulator Order Code 44291531
ACCUMULATOR DISPOSAL
The appliance contains an Ni-MH accumulator. This accumulator type contains substances that may damage the
environment when decomposing. Prior to the appliance disposal or the accumulator replacement, remove the
original accumulator and take it to a designated collection yard.
WARNING!
Never throw the accumulator into a fire!
Never disassemble the accumulator!
Never shorten the accumulator terminals!
Be careful when the accumulator is damaged and leaks; the accumulator electrolyte solution is of alkali nature.
When your skin gets sprayed, rinse it immediately with water and soap and seek medical assistance.
For removing or replacing the accumulator, loosen the screws and demount the appliance's body (Fig. 9). Disconnect
VP4290
Cause
Accumulator is discharged.
Dust receptacle full or
clogged.
Obstructed filter.
Clogged nozzle or turbo
brush of the vacuum cleaner.
The accumulator service life
is over.
Slight heating of the vacuum cleaner is normal and cannot be considered
a failure.
Price according to the pricelist in force
Price according to the pricelist in force
Solution
Charge the accumulator.
Empty and clean the dust receptacle.
Clean or replace the filter.
Check and clear the air passage on the suction
and discharge sides.
The accumulator needs to be replaced. Contact
an authorized service center.
29