Troubleshooting; Optional Accessories - Concept VP 807 Serie Bedienungsanleitung

EN
3. Remove the motor filter (Fig. 4). You can clean the filter by tapping it. If the filter is heavily soiled, you may
wash it in lukewarm water and let it dry properly.
4. Insert the cleaned or new motor filter into the appliance and close the cover.
CLEANING AND REPLACING THE AIR OUTLET FILTER
1. Open the air outlet grid in the appliance's rear section (Fig. 5).
2. Remove the air outlet filter. You can clean this filter by tapping it, then brushing it with a soft brush. After
this operation is complete, you may clean a very dirty filter by washing and brushing with a soft brush in
lukewarm water with no cleaning agents added. It is important to let the wet parts dry thoroughly. A wet
filter will be damaged by vacuuming! Do not use a hair dryer to dry it!
Note: Wet cleaning may cause more wear and tear of the filter and, consequently, may shorten its service
life.
3. Insert the cleaned or new air outlet filter into the appliance and close the air outlet grid.

TROUBLESHOOTING

Problem
Motor does not run.
Motor has stopped
operating.
Front cover cannot be
closed
Reduced suction power
Vacuum cleaner heats up

OPTIONAL ACCESSORIES

The following appliance accessories can be purchased additionally:
Dust bags (5 units + 2 units of motor filters)
56
Cause
Plug inserted into the
mains outlet incorrectly or
insufficiently.
The mains outlet is not live.
Improper or insufficient air
flow. Motor overheating
fuse activated.
Dust bag inserted
incorrectly.
Dust bag full or clogged.
Obstructed filter.
Clogged nozzle, tube, or
hose.
Slight heating of the vacuum cleaner is normal and cannot be considered
a failure.
Order code SMS9000
Solution
Check the plug connection.
Check for voltage, e.g. by connecting
another appliance.
Disconnect the cable from the socket.
Check and release the air suction
and discharge holes; check the filter's
cleanliness and/or replace the dust bag.
Let the vacuum cleaner cool down.
Check the dust filter installation.
Replace the dust bag.
Clean or replace the filter.
Check and clear the air passage on the
suction and discharge sides.
Price according to the valid price list
VP 807x