Cleaning And Maintenance - Concept VP4290 Bedienungsanleitung

1. Remove the appliance from the charging base (Fig. 3).
2. If needed, apply the respective accessory (Fig. 4, 5, 6, 7).
3. Turn the appliance on by shifting the switch (3). Vacuum clean the required area with slow motions back and forth.
4. After use, turn the appliance off by shifting the switch (3).
Fig. 4
DUST RECEPTACLE CONTENT LEVEL CHECK
If the appliance's suction power is decreased, or the dust receptacle (1) is full, empty it and clean the appliance's filter
(Refer to the paragraph on emptying the dust receptacle).

CLEANING AND MAINTENANCE

You can clean the accessories and the appliance with a wet cloth.
Do not immerse the power cord, charging adaptor, or appliance into water
or any other liquid.
Do not use any aggressive substances for cleaning, such as solvents or abrasives!
As a preventive measure, we recommend emptying the dust receptacle (1) and
cleaning the filter of the vacuum cleaner after each use.
DUST RECEPTACLE EMPTYING
1. Disconnect the charging adaptor (E) from the wall outlet.
2. Hold the appliance with the dust receptacle (1) pointing downwards.
3. Release the dust receptacle (1) by pressing the pawl (2). (Fig. 8)
4. Take out the filter and empty the appliance's dust receptacle (1).
5. Follow the reverse procedure to put back the filter, and reinstall the dust
receptacle (1).
PERMANENT FILTER CLEANING AND REPLACING
This filter can be cleaned by mechanical shaking and cleaning with a soft brush.
After this operation is complete, you can clean a very dirty filter by washing and
rubbing with a soft brush in lukewarm water without any cleaning agents added.
It is very important to let the wet parts dry thoroughly. A wet filter would get
damaged by suction! Do not use a hair dryer for drying!
Note: Wet cleaning may cause more wear and tear of the filter and, consequently,
shorten its service life.
28
Fig. 5 Fig. 6
EN
Fig. 7
Fig. 8
VP4290