Special Equipment - Internal Data Memory; Adjustment Of The Operating Mode And The Adjustment Ranges . 24 - MBZ EP-1 Original - Betriebs- Und Montageanleitung

11.1.3. Special equipment
Internal memory:
The below listed values are saved at the control unit BEKA-troniX1. They can be read out or
changed with the diagnosis software BEKA-DiSys:
− Controlling type
− Version of control unit
EN
− Serial number
−
Manufacturing date
−
Operating mode
− Set parameters (adjusting ranges)
The control unit EP-tronic additionally saves the following values:
− RTC (Real-Time-Clock) date and time, also adjustable for other time zones
− Operating hours
− Running time of the pump
− Number of intermediate lubrication
− Number of filling errors
−
Number of excess pressure errors
−
Number of stroke monitoring errors
− Number of revolution monitoring errors
− Date and time of last diagnosis
− Number of total diagnosis
− List of the last 100 errors with error type, as well as indication of time and date
24
− List of the last 100 changes of the adjustment with time and date
For a modification of the above mentioned values is the diagnosis software BEKA-DiSys as well
as a data cable necessary (see description BEKA-DiSys).
11.1.4. Adjustment of the operating mode and the adjustment ranges:
The modes and the adjusting ranges can be changed by means of the diagnostic software
BEKA-DiSys.
All adjusting ranges for the lubrication time can be combined with all cycle time ranges.
Adjusting ranges BEKA-troniX1:
Lubrication times:
1 to 16 min. (16 notches every 1 min.)
2 to 32 min. (16 notches every 2 min.)
2 to 32 sec. (16 notches every 2 sec.)
Revolutions of the pump:
1 to16 revolutions (16 notches every 1 revolution)
10 to 160 revolutions (16 notches every 10 revolutions)
170 to 320 revolutions (16 notches every 10 revolutions)
BEKA 2016 All rights reserved!
...a product of BEKA
Cycle times:
0.5 to 8 h (16 notches every 0.5 h)
2 to 32 min. (16 notches every 2 min.)
2 to 32 h (16 notches every 2 h)
System analysis
port