Assembly Manual; Overview And Installation Dimensions; Central Lubrication Pump Ep-1 And Fkggm-Ep With Steel Reservoir - MBZ EP-1 Original - Betriebs- Und Montageanleitung

5.

Assembly manual:

EN
Set up the grease lubrication pump horizontally on both sides at the place where it has to be
installed! Pay also attention to the mentioned data regarding the fastening bore in the
dimensioned drawing.
Special measures for the noise prevention and for the vibration reduction of the grease
lubrication pump during the installation don't have to be taken.
Pipeline and hydraulic hose line assembly
•
Layout must be expert. Assemble free from distortion.
•
Comply with the pressure seal tightness of the threaded joints.
•
Please observe the permitted pressure range of the pipeline and the hydrauc hose line.
Electrical connection
10
6.

Overview and installation dimensions:

6.1.

Central lubrication pump EP-1 and FKGGM-EP with steel reservoir:

Model with
2 kg reservoir
BEKA 2016 All rights reserved!
...a product of BEKA
The following conditions have to be satisfied during the assembly of this
grease lubrication pump, thus it can be assembled, with other parts, to a
complete machine without affect the safety and health of human.
•
Current supply may only be made by professional electricians
•
The electrical components of the system must be wired expert.
•
Compare the voltage details with the existing mains voltage
"X"
Model with
Ø150
4 kg reservoir
Ø9.5
connection
Connecting cable
239
length 10 m
View "X"
172
Pipe
dia.6
152
130
137.5
321