3-Brush Sweeping System Attachment (Ex Works); View Of The Device For A 3-Brush Sweeping System; Requirements For Removal/Installation; Removing The 3-Brush Sweeping System - Kärcher MC 250 Betriebsanleitung

2.3 3-brush sweeping system attachment (ex
works)
2.3.1 View of the device for a 3-brush sweeping
system
Front brush
1
Front brush arm
2
Side brushes (2-brush sweeping system)
3
Linear unit (carriage)
4

2.3.2 Requirements for removal/installation

A changing carriage is required for removing/attaching the
sweeping system.
Note
Optional accessory, order no. 2.852-862.0
1 Park the vehicle on a level surface.
2 The brush system must be sitting on the changing car-
riage for removal/installation from/on the vehicle. Use a
lift truck for removal/installation.
3 The corresponding > Sweep < program must be select-
ed on the display.

2.3.3 Removing the 3-brush sweeping system

Changing carriage 2.852-862.0
1
Short locking plate
2
Long locking plate
3
Retaining clip (2x)
4
1. Remove the 3-brush sweeping system with the option-
ally available changing carriage.
2. Stop the vehicle on level, solid ground and secure it
against rolling away.
36
3-brush sweeping system
1
Changing carriage
2
MC 250
3
Lift truck
4
3. Move the changing carriage into position under the ve-
hicle using the lift truck.
4. Move the side brushes individually into the side brush
holder and lower into the correct position.
Brush arm for front brush
1
Long locking plate
2
Retaining clip
3
5. Secure the brush arm for the front brush with a locking
plate and retaining clip.
Front brush
1
Short locking plate
2
6. Secure the front brush with a locking plate.
7. Depressurise the front hydraulics. See chapter "Depres-
surising the hydraulic system".
English