Maintenance Works; Cleaning And Care; Frost Protection - Kärcher BR 30/4 C Bp Originalbetriebsanleitung

 Cleaning the waste water tank: Drain
the waste water tank and rinse it with
fresh water. Clean the seals between
the waste water tank and the device.
 Rinse the appliance: Fill the fresh water
reservoir with clear water (without de-
tergent) and let the appliance run for
one minute with the brush water supply
turned on.
 Remove the remaining water from the
fresh water tank.
 Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
 Clean the vacuum bar, check for wear
and replace if required (see "Mainte-
nance tasks").
 Check the brush for wear and replace if
required (see "Maintenance tasks").
Yearly
 Have the prescribed safety inspection
carried out by an electrician.

Maintenance Works

Replace the vacuum bar.
Note:
The vacuum bars are attached to the appli-
ance with snaps and can simply be pulled
off.
 Set the suction bar lifting pedal to the
"suction" position ("1/ON" position).
 Remove the fresh water reservoir.
 Remove the waste water tank.
 Lay the device on the reverse.
 Pull off the vacuum bar downwards.
 Insert the new vacuum bars and lock
them into place.
Replacing the brush roller
 Remove the fresh water reservoir.
 Remove the waste water tank.
 Lay the device on the reverse.
 Press the release button for the brush
roller and swivel the brush roller toward
the bottom and pull it off the driver.
 Place the new brush roller on the driver
and lock into place on the opposite side.

Cleaning and care

Clean water distributor
 Remove the roller brush (see "Chang-
ing the roller brush").
Illustration
 Pull out the water distribution strip in the
brush tunnel.
 Clean the irrigation channel and the
opening in the water distribution bar un-
der running water.
Clean suction tube
 Remove the fresh water reservoir from
the appliance.
 Swivel support bow downward and re-
move the waste water tank.
Illustration
 Pull the connection between the suction
pipe and the suction hose to the rear out
of the device and swing out the suction
pipe and suction hose.
The suction tube is separated and both
ends are accessible for cleaning.
Illustration
 Pull the suction bar downwards, the
suction channel in the cleaning head is
accessible for
cleaning.
 Flush the suction hose and the suction
channel with water or pull or push the
obstruction out with a blunt object.

Frost protection

In case of danger of frost:
 Empty the fresh and dirt water reservoirs.
 Store the appliance in a frost-protected
room.
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your accessory within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.
– 5
EN
Warranty
15