Operation - Klarstein 10029241 Bedienungsanleitung

EN
42

OPERATION

Cooking
Touch the On/Off key. After switching on, there
1 is a beep. All displays show "-" or "--". This
signals the standby mode.
Place a suitable pot on the hob. Make sure the
2 bottom and surface of the hob are clean and
dry.
Touch the selection of the hob. The indicator
3
next to the key starts to flash.
Select the temperature level by pressing "-" or
4
"+".
Note: If you have not selected a temperature within one minute, the induction
hob switches off automatically and you must start again with step 1. You can
adjust the temperature at any time during cooking.
If the display flashes alternately with and the temperature setting, it
means:
• that you have not placed the pot correctly on the hob in question
• that the pot you are using is not suitable for induction cooking
• that the pot is too small
• that the pot has not been placed correctly in the center of the hob.
If a suitable pot has not been placed, no heating will take place. Without a suitable
pot, the display goes off after one minute.