Installation - Klarstein 10029241 Bedienungsanleitung

EN
34

INSTALLATION

Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing. For the
purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole. Be sure the thickness of the work surface is at least 30 mm.
Please select heat-resistant and insulated work surface material (Wood and similar
fibrous or hygroscopic material shall not be used as work surface material unless
impregnated) to avoid the electrical shock and larger deformation caused by the
heat radiation from the hotplate. As shown below.
Note: The safety distance between the sides of the hob and the inner surfaces
of the worktop should be at least 3 mm.
Note: The dimensions given in the table are „mm".
L W H
590 520 55
Under any circumstances, make sure the Induction cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the induction cooker hob is in
good work state.
D A
58 560 490
B X
min. 50
F
min. 3