Getting Started And Operation - Klarstein MULTICHEF 4 Bedienungsanleitung

GETTING STARTED AND OPERATION

The position of the corresponding gas burner is indicated on each control knob.
Gas burners
The burners are different in size and power. Choose the most appropriate one for the
diameter of the cookware being used.
The burner can be regulated with the corresponding control knob by using one of the
following settings:
OFF
High
Low
On those models fi tted with a safety device
The knob must be pressed for about 6 seconds until the fl ame is lighted and warmed up.
On those models fi tted with an igniter
The electric ignition button, identifi ed by the symbol, must be pressed fi rst, then the
corresponding knob is pushed and turned in the counter-clockwise direction to the
"High" setting.
To light a burner: Simply press the corresponding knob and turn it in the counter-
clockwise direction to the High setting, keep press until the burner is lighted.
CAUTION
Fire and explosion hazard! If the fl ame goes out accidentally, turn off
the gas with the control knob and try to light it again at least 1 minute
later.
To turn off a burner: Turn the knob in the clockwise direction until it is stopped (it should
be on the "·" setting).
Ceramic burner
To turn on the ceramic burner: Turn the knob in the
clockwise direction.
To select a heating level: The number around the outside
of knob indicates the power level that you have set the
zone.Each cooking zone can be adjusted between 1 and
9, one being the coolest zone setting and nine being the
hottest zone setting.
EN
35