Carrying Out A Full Cleaning; Storage; Disposal - Silvercrest RAP11ST Montage-, Bedienungs- Und Sicherheitshinweise

thoroughly in clean water, then
dry.
Wipe the appliance and the at‑
tachment parts with a moist cloth.
Use a little mild soapy water if
needed. Then dry off everything
thoroughly.
Replace the blade
ing. Then turn the blade lock
anti‑clockwise (in the direction
of the arrow) to reattach it.
Carrying out a full
cleaning
CAUTION! Risk of injury from sharp
blade ! Do not move the position‑
13
ing plate near to the blade
10
during assembly, disassembly or
cleaning.
Proceed with cleaning as de‑
scribed in the chapter "Cleaning
after each use".
Turn the turning handle
the "0" setting to ● and remove
the positioning plate
Wipe the positioning plate
with a moist cloth and then dry
it thoroughly.
Move the turning handle
position ►. Then replace the po‑
sitioning plate
after clean‑
13
12
13
past
11
.
10
10
into
11
by pressing it
10
in the middle and then turn the
turning handle back to "0".
To check that it is positioned
correctly, adjust the cutting width
as described in the chapter "Ini‑
tial use". If this does not work,
remove the positioning plate
again and repeat the process.

Storage

Be aware that the turning handle
must be set to "0" during
11
storage.
Wrap the mains cable
the cable winder
the plug (see fig. C).
Only store the appliance when
it is folded together (see fig. A).
Store the appliance out of reach
of children. There is a risk of in‑
jury from the sharp blade

Disposal

The packaging is made entirely of
recyclable materials, which you
may dispose of at local recycling
facilities.
10
around
15
and attach
14
.
13
GB/MT 51