Konig + Neurath TALO.S Bench Montageanleitung Seite 55

No. Description
36 Plug detection in
M1 motor socket
37 Plug detection in
M2 motor socket
38 Plug detection in
M3 motor socket
61 Actuator changed
55 Synchronization lost
motor group 1
56 Synchronization lost
motor group 2
67 High voltage
81 Internal error
You must follow the safety instructions! Improper use of
the system poses a risk of material damage and personal
injury!
Remedy
Plug in the correct motor to the
motor socket that shows the error.
Reset all motors.
Remove load from desktop.
Reset all motors,
if error occurs after reset again,
contact the customer service.
Unplug power cord and
contact the costumer service.
Make a manual reset.
Unplug power cord and plug it in
again after a few seconds.
If this error occurs frequently,
unplug the power cord and contact
the customer service.
52