Check Before Starting; Starting And Stopping; Starting A Cold Engine; Starting A Warm Engine - Husqvarna 129C Bedienungsanweisung

Check before starting

• Check that the trimmer head and trimmer guard are
not damaged or cracked. Replace the trimmer head or
trimmer guard if they have been exposed to impact or
are cracked.
• Never use the machine without a guard nor with a
defective guard.
• All covers must be correctly fitted and undamaged
before you start the machine.

Starting and stopping

WARNING! The complete clutch cover and
!
shaft must be fitted before the machine is
started, otherwise the clutch can come
loose and cause personal injury.
Always move the machine away from the
refuelling area and source before starting.
Place the machine on a flat surface.
Ensure the cutting attachment cannot
come into contact with any object.
Make sure no unauthorised persons are in
the working area. Otherwise there is a risk
of serious personal injury. The safety
distance is 15 meters.

Starting a cold engine

Primer bulb: Press the air purge diaphragm repeatedly
until fuel begins to fill the diaphragm (about 10 times). The
diaphragm need not be completely filled.
14 – English
STARTING AND STOPPING
Choke: Set the choke control in the choke position.
WARNING! When the engine is started
!
with the choke in choke position the
cutting attachment will start to rotate
immediately.
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until
you feel some resistance (the starter pawls grip), now
quickly and powerfully pull the cord. Never twist the
starter cord around your hand.
NOTE!
Do not squeeze the throttle control while attempting to
start the engine.
Repeat pulling the cord until engine attemps to start (or
maximum 3 pulls). If the engine starts or attempts to start,
push the choke lever down to the run position. Keep on
pulling the cord powerfully until the engine starts. Once
the engine starts, allow the engine to warm up for 30
seconds before applying full throttle.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.

Starting a warm engine

Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Push the choke lever down to the run position. Keep on
pulling the cord powerfully until the engine starts. Once the
engine starts, apply full throttle.