Introduction; Device Description; Scope Of Delivery - Scheppach HM100MP Original Bedienungsanleitung

1. Introduction

MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
Improper handling,
•
Non-compliance of the operating instructions,
•
Repairs by third parties, not by authorized service
•
technicians,
Installation and replacement of non-original spare
•
parts,
Application other than specified,
•
A breakdown of the electrical system that occurs
•
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
WE RECOMMEND:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its informa-
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety notices contained in this
operating manual and the particular instructions for
your country, the generally recognised technical reg-
ulations for the operation of identical devices must
be complied with.
22 GB
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
2. Layout (Fig. 1-19)
Handle
1.
2. ON/OFF switch
Release lever
3.
Saw shaft lock
4.
Machine head
5.
Movable blade guard
6.
Saw blade
7.
Clamping device
8.
9. Workpiece support
Locking screw for workpiece support
10.
Table insert
11.
Indexed position lever
12.
Locking lever
13.
Pointer
14.
Scale
15.
16. Turntable
Fixed saw table
17.
Stop rail
18.
Scale
19.
Pointer
20.
Sawdust bag
21.
22. Locking screw
Locking screw for drag guide
23.
Fastening bolt
24.
Drag guide
25.
Screw for cutting depth limiter
26.
Stop for cutting depth limiter
27.
Movable stop rail
28.
29. Set screw for moveable stop rail
Adjustment screw (90°)
30.
Adjustment screw (45°)
31.
Flange screw
32.
Outer flange
33.
Laser
34.
ON/OFF switch for laser
35.
36. Battery compartment
Battery compartment cover
37.
Screw
38.
Inner flange
39.
Guide bar
40.
Spring
41.
42. Switch for switching speeds
a) 90° stop angle (not supplied)
b) 45° stop angle (not supplied)
c) Allen key, 6 mm

3. Scope of delivery

Open the packaging and remove the device care-
•
fully.
Remove the packaging material as well as the
•
packaging and transport bracing (if available).