Functional Description - Abicor Binzel BRS-FP Betriebsanleitung

5 Functional description

5 Functional description
The reamer, which is to be adapted to the gas nozzle and torch geometry, is driven by a pneumatic motor and moved by
the guide block in linear direction of the axis of rotation. To adjust the immersion depth of max. 50 mm, the pneumatic motor
is clamped in the guide block.
For cleaning, the torch is clamped with the cylindrical part of the gas nozzle in a precisely defined position in the reamer
holder. No stress is transmitted to the robot due to the four-point bearing. The set of clamping jaws must be adapted to the
external diameter of the gas nozzle, and can be replaced for all sizes from Ø 15 to 30 mm.
An optional injection jig may be mounted on the FPi version. In this BRS-FPi version, the reamer sprays the anti-spatter fluid
into the interior of the gas nozzle after cleaning (signal-controlled). The control system required for this process is fixed to the
housing. It is a PCB and requires 20–30 V DC voltage (externally applied) as well as one robot output and one robot input.
All add-on components (valves, PCB, initiators) are protected against external influences by a covering hood.
8
7
1 Covering hood
2 Set of clamping jaws *
3 Clamping device
4 Reamer *
Fig. 3 BRS-FP/BRS-FPi torch cleaning station
NOTICE
• * These equipment parts must be adapted to the gas nozzle and torch geometry.
EN - 10
BRS-FP BRS-FPi
6
5 Injection unit connection
6 Venturi valve
7 Pneumatic motor
8 Guide block
BRS-FP/BRS-FPi
1
2
3
4
5
BAL.0028.0 • 2021-01-19