Abicor Binzel BRS-FP Betriebsanleitung Seite 44

6 Commissioning
6.8 Setting up the BRS-FP/BRS-FPi torch cleaning station
NOTICE
• Ensure that the torch cleaning station is without compressed air and power supply during setup.
• Ensure that the diameter of the gas nozzle is suitable for the set of clamping jaws.
• Ensure that the distance sleeve matches the nominal diameter of the gas nozzle.
• Ensure that the reamer is suitable for the torch type.
6.8.1 Setting up the pneumatic motor
1
8
7
6
5
4
1 Clamping device
2 Gas nozzle
Fig. 11 Setting up the pneumatic motor
1 Loosen the motor clamp via the set screws (3) and the cylinder head screws (5) on the guide block (6).
2 Pull back the pneumatic motor (4) in its mount.
3 Place the required distance sleeve (8) on the reamer (7).
4 Move the torch with the gas nozzle (2) to the clamping position (C).
5 Keep the guide block (6) in the lower position (stroke down).
6 Place the pneumatic motor (4) against the gas nozzle (2) with the distance sleeve (8) placed on top.
7 Secure the adjusted motor position with the cylinder head screws (5) and set screws (3) (tightening torque 3.4 Nm).
8 Move the torch out of the clamping device (1) and remove the distance sleeve (8) from the reamer (7).
EN - 18
C
3 Set screws
4 Pneumatic motor
2
3
5 Cylinder head screws 7
6 Guide block 8
BRS-FP/BRS-FPi
Reamer
Distance sleeve
BAL.0028.0 • 2021-01-19