Transport And Installation - Abicor Binzel BRS-FP Betriebsanleitung

BRS-FP/BRS-FPi
6 Commissioning
DANGER
Risk of injury due to unexpected start
Improper operation can lead to serious injuries that could result in death.
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Note the following instructions:
 2 Safety on page EN-4
• Only qualified personnel are permitted to perform work on the device or system.

6.1 Transport and installation

CAUTION
Risk of injury
Physical injury due to falling devices and add-on components.
• Use an appropriate lifting tool with load securing devices for transporting and installing the BRS-FP/BRS-FPi robot
welding power source.
• Avoid abrupt lifting and setting down.
• Do not lift the components over persons or other devices.
• Transport the components in an upright position.
• Wear your personal protective equipment: safety shoes with steel toe caps, protective gloves, safety helmet,
ear protectors.
• Send bystanders out of the danger zone.
• Note the weight of the individual components.
 3.1 Technical data on page EN-6
CAUTION
Risk of toppling
Physical injury or damage to components due to improper assembly.
• Disconnect the supply lines.
• Place the components on a suitable base (flat, solid, dry) on which they will not topple over.
NOTICE
• Ensure clear access to the control elements and connections.
• Protect the components against rain and direct sunlight.
• Use the device only in dry, clean and well-ventilated rooms.
1 Fix the optional support to a vibration-free working surface in the robot's work area with four screws.
BAL.0028.0 • 2021-01-19
6 Commissioning
EN - 11