Fitting The Top Rails - Swim & Fun Classic Oval Steel Pool Bedienungsanleitung

Check if the pool liner is placed evenly around the perimeter. Evenly fold the excessive lenght of
the PVC liner over the pool wall if you find it a bit loose. Check if the overlap is uniform. If the pool
liner is slightly short, then you will have to let it down and vice versa.
Fill the pool with 3 to 5 cm height of water to smooth out the liner against the pool wall.
Check to see if the water is level. If not, something is wrong and you will have to dismantle
the liner and pool wall to access and level the ground area.
Important!
If the dimension of the PVC liner is smaller than the steel wall, do not stretch or force
the PVC! Stop the assembly immediately and call customer service for assistance.
9.

Fitting the top rails

Remove one peg at a
time whilst applying the
top rails (Diagram 32).
Slide the pipe connectors
into one end of the top
rail, then connect another
top rail, continue around
the circumference until
all top rails are joined
together and firmly pres-
sed into the top of the
pool wall.
Attention!
Do not cut the excess
overlap off the pool
liner. If you cut the
overlap, it will make the
next pool installation
step difficult. Also do
not tape the overlap to
the top rail, as it will
cause difficultly when
you fix the top rails.
138
MV-2908-2909-2920-2021-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK