Swim & Fun Classic Oval Steel Pool Bedienungsanleitung Seite 130

4.1 Leveling is extremely important
Take as much time as possible to
work out a site that is completely
firm and level. Use a carpenter's
level to ensure that the site is
completely level, flat and firm!.
The pool contains a huge amount
of water and thousands of kilos of
weight. Should the pool collapse
due to unleveled ground, it could
cause a lot of damage to property
and even human injury or death!
Remove the higher ground
rather than filling the low laying
ground.
Mounting with pelvic floor
insulation:
If you cover the pelvic floor with
insulation (shatter-proof), it is
necessary to cover the intire pool.
Place a maximum of a 3 cm thick
flat gravel layer and compress,
then put the insulation into the bot-
tom gravel bed.
Concrete foundation:
For a concrete foundation instruc-
tions are the same, with the con-
crete slab replacing the gravel bed
(thickness depends on the local
conditions about 15 - 20 cm with
iron reinforcement).
Pool installation without floor insulation:
Concrete slabs beneath the bottom rail connectors are not essential for stability and safety, but
their installation is recommended. Otherwise, it may result in subsidence, which can damage the
pool in the sequence. The concrete slab should be recessed flush with the installation location.
Around the pool should be a free space of 1.2 meters to keep children from falling into the pool.
Attention
Always remove grass, roots and stones within the circle. Use the ground cover provided
to ensure that roots and stones doesn't penetrate the pool liner and cause damage.
130
MV-2908-2909-2920-2021-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK