Swim & Fun Classic Oval Steel Pool Bedienungsanleitung Seite 146

Single gasket
A tip to help you fit single gaskets:
• Push a screw through the upper holes on the right and left of the front skimmer frame and the
gasket on the inside of the pool.
• The position of the two screw holes is now marked on the inside of the liner by the two screws
inserted in the front skimmer frame.
• Prick a hole in the liner to mark these two positions.
• Now fit the front frame and skimmer gasket to the inside of the pool.
NB: Both screws must be inserted from the inside and out through the pool wall.
Fit the other skimmer gasket onto the screws on the outside.
The skimmer will now be secured with the screws on the outside of the pool. Now fit the remai-
ning screws in the same way, one after the other, in the skimmer housing. Wait to fully tighten the
screws until all are in place. Once they are in place tighten the screws diagonally and uniformly to
ensure that proper sealing is attained.
146
MV-2908-2909-2920-2021-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK