Swim & Fun Classic Oval Steel Pool Bedienungsanleitung Seite 144

13.2 Step1: Assembling the inlet connector kit
When filling the pool, once the level of water has reached 5 or 6 cm away from the inlet hole, install
the inlet as follows:
Warning!
Never permanently install the skimmer or the inlet before the water arrives to within a
few centimeters of them, because the liner has to be properly taut with the pressure
of the water. Cutting more liner than necessary will damage and void the pool liner, so
please trim with extra care.Caution! Do not damage any part of the inside of the
skimmer box and Inlet and outlet connections with the knife.
144
MV-2908-2909-2920-2021-11-2017 . © All rights reserved Swim & Fun Scandinavia ApS
UK