Mounting The Round Connectors - Sony Magnescale GB-A Serie Bedienungsanleitung

〈10〉 Mounting the round connectors
1 Secure the connected male and female round
connectors with the accessory clamp. Be sure to
secure the connectors, as they are dangerous if loose.
2 Fit the connectors into the open side of the clamp as
shown in the figure. Next, tighten the top and bottom
edges of the clamp together using the two accessory
screws (+B M4×10).
3 Tighten the screws firmly until the top and bottom
edges of the clamp touch. Then check that the
connectors are secured firmly.
Clamp mounting dimensions and outer dimensions
The height dimension after mounting should be the same
as the outer diameter of the connectors.
30/1.17"
54/2.11"
Tighten with binding pan head
screws (+B M4×10).
Fig. 3-18
Clamp
Tighten until the edges touch.
57