Pellet Adjustment; User Menu; Set Clock; Chrono - Dal Zotto DZ LP30 Benutzerhandbuch

PeLLeT ADjusTMeNT

The following menu allows to adjust the percentage of pellet feed. If the stove has functioning problems owing to the quantity
of pellets, adjust pellet feeding directly from the control board.
The problems correlated to the amount of fuel can be divided into 2 categories:
NO FUEL:
Š the stove can never develop a suitable flame, tending to remain very low even at high powers.
Š at minimum power the stove tends to almost switch-off taking the stove into "NO PELLETS" alarm condition.
Š when the stove displays the "NO PELLETS" alarm, there may be non-burned pellets inside the burn pot.
EXCESS FUEL:
Š the stove develops a very high flame even at low power.
Š the panoramic glass is very dirty, obscuring it almost totally.
Š the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only
burned partially.
The adjustment to be performed is in percentage. Therefore a modification of this parameter will lead to a proportional
variation of all stove feeding speeds. Feeding is from -30% to +20%.
CONTROLS PROCEDURE
Š From the main screen, turn P2 to select the SET ADJUSTMENTS icon
Š Press P2 to confirm and successively press P2 again to select PELLET
REGULATION
Š Turn P2 to modify the parameter as a percentage (-30/+20)
Š Confirm and memorising by pressing P2
Š to exit without memorising, press key P1
+

user MeNu

-

seT CLOCK

see chapter: commissioning settings
Š

ChrONO

The chrono allows to program 4 time spans within a day to use every day of the week.
The switch-on and switch-off time can be set in every time slot, along with the days of use of the programmed time slot
and the desired water temperature (65 - 80°C).
RECOMMENDATIONS
The ignition and switch-off times must be within the space of
one day, from 0 to 24 and not over several days:
Before using the chrono function, set the current day and
time. Then check that the points listed in the "SET CLOCK"
sub-chapter have been followed, so that the chrono function
works. Aside from programming it, activate it as well.
TO eNAbLe The ChrONO FOLLOW The INsTruCTIONs As DesCrIbeD IN The "ENABLE CHRONO"
ChAPTer. WheN The WeeKLy PrOgrAMMer Is ACTIVe, The reLeVANT ICON WILL LIghT uP ON The
CONTrOL PANeL
PELLET ADJUSTMENT
EXAMPLE
Switch-on time 07:00
Switch-off time 18:00
Switch-on time 22:00
Switch-off time 05:00
| eNgLIsh
00
COrreCT
INCOrreCT
67