Additional Thermostat; Additional Thermostat Functioning With Stby Active; Additional Thermostat Installation; Aux - Dal Zotto DZ LP30 Benutzerhandbuch

ADDITIONAL TherMOsTAT

There is a possibility to thermostat a room adjacent to the room where the stove is positioned: just connect a thermostat
following the procedure described in the next step (it is recommended to position the optional mechanical thermostat at a
height of 1.50 m from the floor) .
The default sTby function is always active (it cannot be disabled) and the sTby clamp is jumpered (contact closed).

ADDITIONAL TherMOsTAT FuNCTIONINg WITh sTby ACTIVe

When the contact or external thermostat is not satisfied (open contact
As soon as the contact or external thermostat switches to the "not satisfied" status (closed contact
reached) it will re-ignite, after the boiler has cooled down.
N.B.: stove operation depends on the temperature of the water inside the stove and relative factory setting restrictions. If
stove is in H OFF (water temperature reached), any additional contact or thermostat request will be ignored.
ADDITIONAL TherMOsTAT INsTALLATION
Š Switch the appliance off using the master switch positioned on the rear of the stove.
Š Remove the plug from the socket.
Š Refer to the electrical diagram to connect the two thermostat cables onto the relative clamps positioned on the rear of the
machine, one is red and the other one is black (STBy clamp).
The image is given as an example.

AUX

STBY
ATTeNTION:
The CLAMP MusT be FITTeD WITh A "Dry" TyPe CONTACT
(INPuT WITh Dry CONTACT, POTeNTIAL-Free)
N.b. : INsTALLATION MusT be PerFOrMeD by AN AuThOrIseD TeChNICIAN
64
=temperature reached), the stove will switch off.
STBY STBY
STBY
Aux
Connection reserved for Dal Zotto
conveyed waves accessories.
Contact the dealer for further details
The sTby AND Aux
CLAMPs, FOuND AT The
bACK OF The sTOVe
CAN be NOTeD IN The
DIAgrAM AT The sIDe
| eNgLIsh
= temperature to be
STBY