Instant Domestic Hot Water Production Kit; Stove Positioning; Rearm; Thermo-Products Features - Dal Zotto DZ LP30 Benutzerhandbuch

INsTANT DOMesTIC hOT WATer PrODuCTION KIT

WArNINgs: if the instant hot water production kit is to be used, contact the company technical after-sales service.

sTOVe POsITIONINg

For correct product functioning, it is recommended to position it in a way that it is perfectly level, with the aid of a spirit level.

reArM

The figures below show the rearm positions
of the tank (85°C) and H2O (100°C). It is recommended to
contact the qualified technician if one of the rearms should
be triggered, so as to verify the cause.

TherMO-PrODuCTs FeATures

Water content of the thermo product heat exchanger (l)
Volume of expansion vessel integrated into thermo-product (l)
Maximum content of water in the system for integrated expansion vessel (l)*
3 bar safety valve integrated into the thermo-product
Minimum and maximum pressure switch integrated into the thermo-product
Pump integrated into the thermo-product
Pump max. head (m)
*Content of water in the system in addition to that of the
thermo product that can be managed with the integrated
expansion vessel. An additional expansion vessel must be
installed for a higher content of water.
The diagram at the side illustrates the behaviour of the pump
used on our thermo-products at the speeds that can be set.
85°C
AUX
STBY
6
5
4
3
2
1
0
0,0 0,5
Flow rate (m
| eNgLIsh
100°C
DZ LP30
66
12
170
yES
yES
yES
5
1,0 1,5 2,0 2,5
/h)
3
49