General Menu; Basic Instructions - Dal Zotto DZ LP30 Benutzerhandbuch

geNerAL MeNu

seT TeMPerATure
2
seT POWer
2
seT ADjusTMeNTs
2
sTATus
2
user MeNu
2
TeChNIC seT
(reserVeD TO
The quALIFIeD
TeChNICIAN)

bAsIC INsTruCTIONs

The following recommendations must be followed the first
times the stove is ignited:
It is possible that slight odours are produced due to the
Š
drying of the paints and silicones used. Do not remain in the
environment for long periods.
Do not touch the surfaces as they could still be
Š
unstable.
Air the room well several times.
Š
The hardening of the surfaces is terminated after several
Š
heating processes.
This appliance must not be used to burn waste.
Š
DO NOT use ANy INFLAMMAbLe LIquIDs FOr IgNITION!
DO NOT ALLOW The bAg OF PeLLeTs TO COMe INTO CONTACT WITh The bOILINg hOT sTOVe DurINg The FILLINg PhAse!
IN The eVeNT OF CONTINuOus NO IgNITION, CONTACT AN AuThOrIseD TeChNICIAN.
2
sTOVe sTATus
Before lighting the stove, the following points must be
verified:
The hydraulic system must be completed in compliance
Š
with the guidelines of the regulations and the manual.
The tank must be full of pellets
Š
The combustion chamber must be clean
Š
The burn pot must be completely free and clean
Š
Check the hermetic closure of the fire door and the ash
Š
drawer
Check that the power supply cable is connected correctly
Š
The bipolar switch in the rear right part must be positioned
Š
on 1.
1
ON/OFF - MeNu exIT.
Press TO ACCess The MeNu.
2
TurN TO: seLeCT, ACCess, MODIFy.
Press TO MeMOrIse.
gO bACK TO The PreVIOus MeNu.
3
eNAbLe ChrONO
PeLLeTs
| eNgLIsh
seT h2O
seT CLOCK
2
seT ChrONO
2
LANguAge
2
DIsPLAy
2
reseT
61