Replacing The Battery; Setting The Units Of Weight; Switching On Your Product / Measuring Your Weight - Silvercrest HG03221A Bedienungs- Und Sicherheitshinweise

3. Open the battery compartment
of the product by pushing the battery compart-
ment cover clip
6
cover toward the battery compartment
5
and lifting off the battery compartment cover
4. Remove the insulating strip
battery.
5. Reattach the battery compartment cover
the battery compartment
the retaining pin on the battery compartment
cover into the notch on the edge of the
5
battery compartment
Firmly press the battery compartment cover
into the battery compartment
it lock into place.
6. Lock the battery compartment cover
the screw.

Replacing the battery

(see Fig. G)
1. Turn the product over and place it on a soft
underlay to avoid scratching the surface.
2. Replace the battery when the product is not in
use.
3. Remove the screw on the battery compartment
cover .
5
4. Open the battery compartment cover
described in chapter „Initial use".
5. Remove the drained battery by pulling the lo-
cking tab until the battery is automatically
8
released. Remove the battery from the battery
compartment .
4
Note: The LC display
replace the battery. When standing on the pro-
duct if the battery is low, the LC display
display "Lo" (see Fig. C) and the product will
automatically switch off.
Note: When the product displays "Lo", re-
place the drained battery with a new battery
of the type specified under „Technical data".
6. Insert a new battery in the battery compart-
ment . Be sure to insert the battery correctly,
4
with the "+" pole up. The battery must be
pushed into the battery compartment
secured in place by the locking tab
16 GB/IE
at the back
4
on the battery compartment
under the
7
5
. Be sure to insert
4
.
4
until you hear
4
with
5
as
5
will show then to
1
1
until
4
.
8
7. Close the battery compartment
bed in chapter „Initial use". Lock the battery
compartment cover
4
.
5

Setting the units of weight

Note: The standard unit of weight is kilogram (kg).
to
The factory default setting for the product as sup-
plied is "kg".
Press the kg / lb / st button
of weight. The units will be displayed in the
5
LC display
Kilogram (kg):
Pound (lb):
Stone (st):
Switching on your product /
measuring your weight
Tip: Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
Place the product down on a solid, flat horizon-
tal surface.
Step on to the product.
Place even weight on each leg.
If at all possible stand on the same areas of the
platform each time and do not move. Moving
during the weighing process can lead to
discrepancies in the results.
will The product will start to measure immediately.
After blinking 3 times, the weight display will
display the result, as shown in, for example, Fig. B.
Note: If the product shows "oL" (see Fig. D), it
signals that the product is overloaded. Observe
the maximum capacity of 180 kg (396 lb / 28 st).
Step off the platform
off automatically after about 10 seconds. Until
then the weight measurement remains visible.
4
with the screw.
5
to select the unit
3
as follows:
1
see Figure A
see Figure E
see Figure F
. The product switches
2
as descri-